The SOTA Magnetic Pulser offers the benefits of a pulsed magnetic field to help balance the body's natural electricity for greater well-being. The Hand Paddle can be applied anywhere on the body. This unit has a built-in timer for 20-minute sessions.
The SOTA Magnetic Pulser can be used for lymph and tissue electrification anywhere on the body. A variant, pulsed electromagnetic field creates the necessary microcurrents of electricity in the lymph or tissue. The Beck Protocol suggests using this device on the lymph nodes concurrently with blood electrification. In addition, the Magnetic Pulser offers the proven benefits provided by the use of static maboth. gnets. Bio-north is clearly marked on the coil. We find it's a handy item to use on a regular basis while watching television and the automatic pulsing feature makes it easy to do
3rd Step of the Robert C. Beck Protocol:
3. High-intensity Pulsed Magnetic Fields: Externally applied magnetic pulses to the lymphatic system, the spleen, kidney & liver, help neutralize germinating, latent and incubating parasites of all types, helping to block re-infection. This speeds up the elimination of disease, restores the immune system, and supports detoxification. Permanent magnets, no matter how strong they are, will not produce the same results as the pulsed fields of Bob Beck's device, which produces induced back-emf currents. You must have a high-intensity, time-varying, magnetic impulse, not just a magnetic field. Magnets have their uses, but they work in different ways with different results. Our Magnetic Pulse Generator produces the correct high-intensity field as specified by Dr. Beck.
High-intensity Pulsed Magnetic Fields: The third step in the Beck Protocol is externally applied magnetic resonance of lymph, spleen, kidney and liver, which helps to neutralize germinating, latent alien invaders and thus blocks reinfection. This quickens disease elimination, restores the immune system and supports detoxification. Detoxification is essential because you are throwing off millions of dead and dying bugs. Permanent magnets, no matter how strong, will not nor cannot scavenge pathogens with electromotive force. It is important to be able to deal with rapid detoxification without producing tremendous discomfort. One of the worst things you can go through is detoxification if you are the slightest bit sick. If you go too fast, and don't detoxify, you have done more harm than good. We go by the motto, "First, do no harm." There are ways to prevent this discomfort, and we will get into that in a few minutes.
After considerable experimentation on himself, friends, acquaintances and a few individuals diagnosed with AIDS, all reaped some health benefit. Soon, however, he realized that the blood might be cleared of viruses or other pathogens but these same pathogens could be temporarily hiding in the lymph system. To create the necessary microcurrents in lymph and tissue to neutralize viruses and other pathogens, he developed a magnetic pulse generator. Pulsed magnetic fields create microcurrents in lymph and other tissue. Externally applied magnetic pulses to the lymphatic system, the spleen, kidney & liver, help neutralize germinating, latent and incubating parasites of all types, helping to block re-infection. This speeds up the elimination of disease, restores the immune system, and supports detoxification. Permanent magnets, no matter how strong they are, will not produce the same results as the pulsed fields of Bob Beck's device, which produces induced back-emf currents. You must have a high-intensity, time-varying, magnetic impulse, not just a magnetic field. Magnets have their uses, but they work in different ways with different results. Our Magnetic Pulse Generator produces the correct high-intensity field as specified by Dr. Beck.
 |
More energy
From a physics perspective, the energy foundations of life is based on electromagnetism. |
|
Better sleep
Use the Magnetic Pulser as an alternative treatment for sleep. |
|
Pain relief
Magnetic therapy provides a natural and alternative pain treatment. |
|
Sports performance
Many elite athletes around the world are successfully using pulsed electromagnetic fields as an alternative therapy to peak out their sports performance. |
|
Detoxification
Use the Magnetic Pulsars' pulsed magnetic fields assist in the removal of waste and toxins in the body. |
|
Stress relief
Pulsed electromagnetic fields (PEMF) prevent and manage stress reactions in the body. |
|
Healthy aging
Electromagnetic therapy is a holistic approach for anti-aging. |
|
Anti-inflammatory
Complementary way to relieve pain and inflammation and promote healing. |
High Intensity Momentary Time-Variant Pulsed DC Magnetic Field Therapy Generator
MODEL #: MP5
"First Aid Kit of the Future"
What is "The Magnetic Pulser"?
The Magnetic Pulser is a professionally designed quality unit, thoroughly tested and guaranteed to operate as per the specifications. The Magnetic Pulser (MP) is designed to generate an intense (~6,000 Gauss*), momentary (~2.5mS) pulsed DC magnetic field (click here to see the actual waveform). For Gauss calculations, and an in-depth discussion on the electrical principles at play with an MP, click HERE.
*Magnetic flux intensity follows the inverse square rule - the further you are away from the magnetic core, the faster the Gauss intensity drops off. At face of Magnetic Coil, the Gauss is ~6,000 Gauss.
NOTE: Please do not confuse this unit with permanent/ceramic magnet therapies, or with the EMR (electro-magnetic radiation) producing units!
Through the principle of induction, this magnetic field creates eddy-currents (tiny electrical micro-currents) in living organic material that contain an electrolyte such as saline. Designed to be used with The Silver Pulser or independently. Targets specific areas.
New Features of model MP5:
New streamlined unit. - Quartz crystal Micro-Computer controlled functions for precise waveform generation and accurate timing sequences.
- Red Light indicates when Magnetic Pulse has been delivered to the Hand paddle/Coil.
- New AUDIBLE output option. When selected, the MP5 will beep each time the Magnetic Pulse has been delivered to the Hand paddle/Coil.
- Unit will pulse for 20 minutes (255 pulses) before resetting.
- Slightly higher output pulse intensity.
- New soft carrying case for easy storage.
Unique Features:
- New Hand-Paddle design. Our pulsing coil has been re-designed into a custom molded plastic enclosure complete with clear identification of the Bio-North (-) Magnetic Pole.
- A unique circuit design allows The Magnetic Pulser to operate without the use of a Xenon flashtube allowing for maximum power delivery to the coil.
- Fully Automatic. The MP5 will automatically charge and discharge - no manual pulsing required. An internal Digital Counter allows the MP5 to pulse approximately 20 minutes between resets.
- LED light bar-graph. A light bar-graph consisting of five Green LED lights, illuminates sequentially giving visual indication of the MP5 charging up.
- A Red LED light indicates either the unit has completed a 20 minute cycle of pulses, or an overload condition has occurred.
- AUDIBLE output option. Unit beeps each time magnetic pulse is released to coil.
- Operates from an AC-DC Wall Adaptor (included), or from a 12 Volt DC source like an automobile battery, appropriate solar panel, etc. (NOTE: We have adaptors that have blades for North America, Hong Kong, Europe, and Australia. Please specify when ordering.)
- Extremely high magnetic power output. Generates maximum 42.18 Joules (Watt*Seconds) of energy through the use of a 600uF, 330VDC Custom Photoflash Capacitor. This then produces ~6,000 Gauss* (~6 kilo Gauss) magnetic field inside the coil. (For Gauss calculations, and an in-depth discussion on the electrical principles at play with an MP, click HERE.)
*Magnetic flux intensity follows the inverse square rule - the further you are away from the magnetic core, the faster the Gauss intensity drops off. At face of Magnetic Coil, the Gauss is ~6,000 Gauss as measured on an F.W. Bell Model 5080 Fluxmeter. Click HERE to see the actual Gauss reading at varying distances from the coil.
- High-Frequency Custom Switch Mode Pulse-Width-Modulated (PWM) power supply allows for fast charges and a very lightweight unit. Our PWM power supply is a constant-current design.
- Double-insulated practices used throughout to ensure the greatest electrical safety. Coil is completely enclosed in a custom-molded plastic Hand Paddle. No exposed wires or leads.
- New Professional Capacitor. We now have a Professional Custom Strobe type Capacitor designed specifically for our Magnetic Pulser. The manufacturer rates the capacitor at well over a 30 million (30,000,000) cycles of operation. Compare this with our earlier version model MP2 and MP3 which had a 250,000 cycle life, or to our MP1 which had a 85,000 cycle life, or even to photoflash based pulsers that have 5,000 - 10,000 life cycle. Click HERE to see our MP capacitors.
- Fast charging cycle.
- Overload Protection. Should an overload or fault condition occur in the charging section, a sensor will limit the current, then eventually shutdown the unit until the fault condition is removed.
- Bio-North Magnetic Pole Polarity (-) or South-Seeking is clearly identified on one side of pulsing coil. This gives the user the choice of applying either Bio-North (-) or Bio-South (+) pole energy to the site.
- Our Electrical Circuit Boards are GOLD Plated for extreme reliability and workmanship.
- Compact and lightweight. MP5 unit weighs 3/4 Lbs. (0.3 Kg.), Magnetic coil weighs 1 Lb. (0.4 Kg.). Total shipping weight of complete MP5 with Wall Adaptor weighs ~3 Lbs. (~1.3 Kg.).
- CE Certification\
The Unit
The Magnetic Pulser is housed in a new custom plastic enclosure. A pushbutton turns the Magnetic Pulser on and off. A series of Green lights indicates power is available and visually shows unit is charging. When turned on, the 
Magnetic Pulser will immediately begin to charge up. When fully charged, the stored energy of the capacitor is discharged into the pulsing coil. The Red light will flash indicating the charge has been released. The Magnetic Pulser will then begin another charge cycle.
Should an overload or fault condition occur in the charging section, the MP5 will shutdown until the fault condition is removed. The unit will beep and flash the Red light notifying the user.
After approximately 20 minutes of pulsing the MP5 will turn itself off. This helps prevent continuous operation should the MP5 be left on unattended.
The Magnetic Pulser is packaged in a soft carrying case for easy storage.
Electronics: 
-
The Magnetic Pulser is designed to the highest standards. We have improved on the original design with added features. Our electronic design is unique and efficient making the unit very reliable and powerful. Early designs required the use of a Xenon flashtube. We've completely re-designed The Magnetic Pulser from the ground up using the latest in electronic components. The result is a very powerful, reliable, rugged unit that transfers more energy to the output coil. In addition, we use double-insulation techniques to ensure the greatest in electrical safety. This is of extreme importance!
Specifications (as measured on a Tektronics TDS 210 Digital Real-Time Oscilloscope, and Wavetek AD105 Clamp-On RMS Ammeter)
-
- Energy Storage Capacitor: 600uF, 450 Volts DC Click here to see our MP capacitors
-
- Typical Energy Storage: 36.75 Joules (Watt*Seconds)
-
- Maximum Energy Storage: 42.18 Joules (Watt*Seconds)
-
- Typical Peak Charge Voltage: 350 Volts DC
-
- Maximum Peak Charge Voltage: 375 Volts DC
-
- Minimum Peak Current Discharge into Coil: 150 Amps RMS
-
- Pulse Rise Time: <1.8 uS (microseconds) Click here to see the actual waveform
-
- Pulse Duration: ~2.5mS (milliseconds) Click here to see the actual waveform
-
- Main Coil Inductance: ~2.5mH (milli-henries)
-
- Flux Density: 40,500 Ampere*Turns
-
- Peak Magnetic Field Output: ~6,000 Gauss* (~6 kilo Gauss). For Gauss calculations, and an in-depth discussion on the electrical principles at play with an MP, click HERE.
*Magnetic flux intensity follows the inverse square rule - the further you are away from the magnetic core, the faster the Gauss intensity drops off. At face of Magnetic Coil, the Gauss is ~6,000 Gauss as measured on an F.W. Bell Model 5080 Fluxmeter. Click HERE to see the actual Gauss reading at varying distances from the coil.
-
- Minimum number of Pulse Discharges 30 Million (30,000,000)
Each Magnetic Pulser comes complete with:
International Voltage (220/240 Volt AC 50 Hz Mains) Requirements:
